All articles

How do I put my PRO, PRO LT or PRO Divide backpack in load sling mode?Updated 3 days ago

Our Load Sling gives you the ability to carry gear, meat, or anything bulky between the frame and the bag. This is handy when your bag is full, and you need to take out a load of meat.

STEP 1:
The first step is to disengage the load lifter straps that connect the top of the bag to the shoulder straps. Then from the bottom of the pack, slightly loosen the lower bag attachment buckles that pull the bag tight to the frame. Don’t unclip these; just loosen enough to lift the bag off the frame. Disconnect the side compression straps.

STEP 2:
Keep the bag tighter at the bottom of the frame to make a V shape gap. Place what you’re carrying in the load sling down into the bottom, reconnect the side straps, and pull tight to secure the load. Using the bridge straps (straps going through holes in the top of the frame), connect the load lifter straps to the buckle on the suspension side, and the tale side connects to the bag where the load lifter was connected before. Pull all the straps tight to secure the load, and you are ready to pack out.

Was this article helpful?
Yes
No